ANSI codes in COMMAND.COM

By | 14 Jul 2008
0 Comment

To enable ANSI control codes in command.com, add the following line to %SystemRoot%\system32\CONFIG.NT:

DEVICE=%SystemRoot%\system32\ANSI.SYS

Leave a Reply

Your email address will not be published. Required fields are marked *

To respond on your own website, enter the URL of your response which should contain a link to this post's permalink URL. Your response will then appear (possibly after moderation) on this page. Want to update or remove your response? Update or delete your post and re-enter your post's URL again. (Find out more about Webmentions.)